MB 600 Series: Stainless Steel Ball and Sleeve (Metric) Expansion and anchorage of sleeve in hole wall is achieved by pressing the ball into the sleeve. The MB Series plug is designed for use in base materials from low to high hardness.
Quantities in stock from 3 to 14 mm diameter, also available in inch versions
Corrosion resistant construction
Normal working tolerances 0/+0.1mm
Simple, quick installation
Complete mechanical sealing through anchoring in base material
Sleeve: Stainless Steel DIN 1.4305, AISI 303
Ball: Stainless Steel DIN 1.4301, AISI 304 Sleeve and Ball clear passivated per MIL S 5002. Aerospace Quality.
MB 600 Series: Stainless Steel Ball and Sleeve (Inch) Expansion and anchorage of sleeve in hole wall is achieved by pressing the ball into the sleeve. The MB Series plug is designed for use in base materials from low to high hardness.
Quantities in stock from 0.093 to 0.281 Inch Diameter.
Corrosion resistant construction
Normal working tolerances 0/+0.1mm
Simple, quick installation
Complete mechanical sealing through anchoring in base material
Sleeve: Stainless Steel DIN 1.4305, AISI 303
Ball: Stainless Steel DIN 1.4034, AISI 420 (.093 inch Dia.) DIN 1.4301, AISI 304 (.125 inch-.281 inch Dia.) Sleeve and Ball clear passivated per MIL S 5002. Aerospace Quality.
MB 700 Series: Carbon Steel Ball, Stainless Steel Sleeve Expansion and anchorage of sleeve in hole wall is achieved by pressing the ball into the sleeve. The MB Series plug is designed for use in base materials from low to high hardness.
Quantities in stock from 3 to 22 mm diameters.
Corrosion resistant construction
Normal working tolerances 0/+0.1mm
Simple, quick installation
Complete mechanical sealing through anchoring in base material
Sleeve: Case Hardening Steel DIN 1.0403, AISI 10L15, Zinc plated chromate finish
Ball: Bearing Steel, Heat Treated
MB 800 Series: Carbon Steel Ball and Sleeve with Cr6 Plating Expansion and anchorage of sleeve in hole wall is achieved by pressing the ball into the sleeve. The MB Series plug is designed for use in base materials from low to high hardness.
Quantities in stock from 3 to 22 mm diameter.
Corrosion resistant construction
Normal working tolerances 0/+0.1mm
Simple, quick installation
Complete mechanical sealing through anchoring in base material
Sleeve: Case Hardening Steel DIN 1.0403, AISI 10L15, Zinc plated chromate finish
Quantities in Stock 3 to 12 mm. Sizes 14 to 22 mm upon special request.
Corrosion resistant construction
Normal working tolerances 0/+0.1mm
Simple, quick installation
Complete mechanical sealing through anchoring in base material
Sleeve: Case hardening steel DIN 1.0403 AISI 10L 15, Thick Coat Passivated (Non Cr 6) Finish
Ball: Bearing Steel, Heat Treated
LP 900 Series Sealing Plugs This low pressure sealing plug is installed by pressing the plug into a tapered hole. The surface-hardened but flexible plug achieves anchorage by gripping the hole wall.
Mechanical labyrinth sealing
Satisfactory corrosion protection
Rated pressure performances up to 60 bar (870 psi)
Click to Call
Tell your suppliers you found them on ThomasNet
