Aeroquip series 2088 (Ref. SAE 140339) External Pipe/ Internal Pipe ′′Street Elbow′′ Adapter. Also available in Stainless Steel as part number 259-2088
Aeroquip series 2251 External Pipe Swivel/ External Pipe Adapter. NOTE: This adapter is not a rotating union or swivel joint. Care must be exercised to avoid misuse. To be used with petroleum or water glycol fliuds.
Aeroquip series 2252 External Pipe Swivel/ Internal Pipe Adapter. NOTE: This adapter is not a rotating union or swivel joint. Care must be exercised to avoid misuse. To be used with petroleum or water glycol fliuds.
Hydraulic adapters in this category include pipe to SAE 37º JIC flare, external pipe to SAE 37º JIC flare bulkhead, internal pipe to 37º flare bulkhead, pipe to 37º flare swivel, female pipe to female swivel, internal pipe to 37º flare. These adapters are available in a wide range of configurations including straights, 45º and 90º elbows, tees and crosses.
Pipe to 45º Flare adapters are found in this section and include straights, 45º and 90º elbows. Configurations include external (male) pipe to 45º flare in straight and elbows, internal (female) pipe to 45º flare in straight and 90º elbow configurations. SAE specifications covered include SAE 010102, 010103, 010302, 010202 and SAE 010203.
An SAE J512 45º Flare is an American Connection commonly used in refrigeration, automotive and truck piping systems. Usually made of brass, both the male and female connectors have 45º seats. The seal takes place between the male flare and the female cone seat. The threads hold the the connection mechanically.
The SAE J514 straight thread O-Ring Boss (ORB) is an American Connection and is recommended by the N.F.P.A for optimum leakage control in medium and high pressure hydraulic systems. The male connector has a straight thread and an O-Ring. The female port has a straight thread, a machined surface (minimum spot-face) and a chamfer to accept the O-Ring. The seal takes place by compressing the O-Ring into the chamfer and the threads hold the connection mechanically.
Hydraulic adapters in this category include male and female SAE O-Ring Boss connections to male and female pipe configurations in straights, 45º and 90º elbow configurations.
The SAE J514 37º Hydraulic connection is very common in fluid power systems. Both the male and female halves of the connections have 37º seats. The seal takes place by establishing a line of contact between the male flare and the female cone seat. The threads hold the connection mechanically.
Hydraulic Adapter JIC flare fittings in this category include unions, bulkhead connections, flare plugs and caps, Female JIC to Male JIC, Reducers, 45º and 90º elbows in standard and long lengths, hydraulic adapter tees and crosses.
Tell your suppliers you found them on ThomasNet
