ST1 1/2-A/ST40-A Type 4 Containment Duty Pump This pump is part of the Containment Duty Pumps. It is specially fitted with PTFE diaphragms as well as elastomeric or elastomeric/PTFE driver diaphragms. The liquid-filled spill chambers provide an additional chemically-resistant barrier, should a pumping diaphragm fail. The Spill Containment design gives the pump user advanced warning of diaphragm failure, before pumpage can damage the air valve or be released into the work environment. Three optional leak detectors available for this model:
Mechanical VIP Leak Detector 031-025-000
Electronic Leak Detector (115V) 032-043-000
Electronic Leak Detector (220V) 032-043-000 The Containment Duty pumps offer many different levels of materials and spill monitoring devices designed to fit a variety of applications and budgets.
ST1-A/ST25-A Type 4 Containment Duty Pump This pump is part of the Containment Duty Pumps. It is specially fitted with PTFE diaphragms as well as elastomeric or elastomeric/PTFE driver diaphragms. The liquid-filled spill chambers provide an additional chemically-resistant barrier, should a pumping diaphragm fail. The Spill Containment design gives the pump user advanced warning of diaphragm failure, before pumpage can damage the air valve or be released into the work environment. Three optional leak detectors available for this model:
Mechanical VIP Leak Detector 031-025-000
Electronic Leak Detector (115V) 032-043-000
Electronic Leak Detector (220V) 032-043-000 The Containment Duty pumps offer many different levels of materials and spill monitoring devices designed to fit a variety of applications and budgets.
F424 Sealless Pump ′′In Good Contact with the Liquids′′ The liquids to be pumped are abrasive, but they do not leave any deposits. Dry running of the pump must not cause any problems. You are looking for a general purpose pump without a mechanical seal in the liquid section. The O-ring material FKM is not resistant to the liquids to be pumped.
The inner tube supports the pump shaft, which is lubricated by the liquid. The level of the liquid in the inner tube always corresponds to that in the drum or container.
F427 Sanitary Pump ′′Pure Culture in Pumping′′ You want a safe pumping of food, cosmetic or pharmaceutical products. The operating conditions require an easy and quick cleaning or sterilization of the pump at regular intervals to avoid any contamination of the product, e.g. when pumping varying liquids or different colors as well as quick-drying or film forming liquids.
The efficient FLUX sanitary pump has been especially designed for aseptic applications.
F560-S & F560-S3A Sanitary Pump Recommended for transferring Thin to high viscosity, even pasty, still free flowing substances.
Seal type Mechanical seal
Available drive motors Three-phase electric motors or compressed air motors
Scope of supply A complete eccentric worm-drive pump consists of: drive motor, pump, stator and hose connection. With higher viscosities delivery rate will be lower, depending on the velocity of the fluid. Values ±10% at 930 rpm. Delivery rate depends on the velocity of the fluid.
Available drive motors Three-phase electric motors
Scope of supply A complete horizontal pump consists of: drive motor, pump and stator, hose connection on inlet and outlet, base plate.
F560-GS Sanitary Pumps Recommended for transferring Thin to medium viscosity liquids up to maximum 30.000 mPas (cP).
Seal type Mechanical seal
Available drive motors Commutator motors or compressed air motors. An infinite variable speed variator - also on explosion-proof motors - allows the operator to set pump capacity to specific delivery requirements.
Scope of supply A complete sanitary pump consists of: drive motor, pump, stator and hose connection.
Tell your suppliers you found them on ThomasNet
