206 Series Lock System This lock is intended primarily for passenger doors on vehicles. Certified to meet the Federal Motor Vehicle Safety Standard No. 206 and to comply with established OSHA safety standards, this lock can be installied on doors as thin as 13/16 inches inner skin to inner skin or the inner surface of a door panel. It can be used for direct operation, remote operation or a combination of both. The lock is designed so there is no concern about accidental lockouts because the inside thumb latch kicks out automatically when the door is slammed. The split tumbler allows locking or unlocking from inside or outside. Provision is made for vertical or thumb rotary locking and unlocking from the inside. And the mechanism is enclosed to minimize damage from foreign objects. The striker is designed for primary and secondary latching capability.
Dimensions:
Length of case - 4 3/8 inch
Width of case - 5 inch
Width of case with striker - 5 27/64 inch
Depth of case - 3/4 inch
Depth of case with striker - 1 11/64 inch
17/64 inch - Mounting holes (4) on 3 inch x 3 5/8 inch (HxV) pattern
9/32 x 13/32 inch - oval mounting slots (2) on 3 1/8 inch centers on striker
Lightweight 16 gauge steel channel is as strong as rod but offers significant cost savings.
Riveted, long-wearing nylon rollers are extra-large diameter (1 1/4 inch) to provide firm, snug closure.
Easily installed on any metal cabinet (including NEMA) 72 inch or shorter. No changes necessary in Jigs or set-ups for riveting, bolting or welding brackets.
As a component part can be used with a NEMA system.
Will accept any handle with 5/16 inch square shank, threaded or not.
Comes complete with two L-brackets for bolting or welding and center cam latch.
36 inch Rod is standard on No. 2500. When 48 inch rod is desired, specify No. 1-2500U.
These handles have ′′O′′ Rings for oil and moisture sealing.
Drop-T Handle Locks Similar to No. 8000 except Key-locking. Two keys furnished.
For small doors, electrical panels, cabinets, lockers, etc. Installed with screws, rivets, welding or blind mounting bracket. Option - Non Key-Locking Variation - Standard slide bolt.
Rotary Lock Rotary lock designed for remote actuation from cable or rods. Supplied with striker.
Paddle Handle Locks Available In Locking Style 2319A (Available W/rubber Moisture Protector) and Non-locking Style 23198. 4 1/2′′ X 3 1/2′′ X 1 1/2′′ Hole Cut 3 3/8′′ X 2 3/8′′ Mounting Studs Available on A & B in Quantity.
Paddle Handle Locks The dead-bolt version of Eberhard′s downsized slam latch (No. 3896) can be used with standard 5/6′′ dia. rods. When coupled with the Eberhard 561 slam- action strike, it can be used in tight spaces where a standard end-bolt won′t fit. The patented dead-bolt feature combines the paddle with the rod, allowing the rod to be retracted while the paddle is activated. The paddle is retained by a spring-loaded detent until closed. Even though the new design is more compact, the latch will still accommodate the standard sized components used with Eberhard′s larger latches (i.e., rods, cable and end-bolts). Choice of zinc plating or stainless steel finish. Available with or without mounting holes.
Tell your suppliers you found them on ThomasNet
